Home > Exhibition > Content
Introduction of laying welding of PVC sheet
Apr 25, 2017

PVC plate is also known as decorative film, adhesive film, should be used in building materials, packaging, medicine and many other industries. Building materials industry accounted for the largest proportion of 60%, followed by the packaging industry, there are a number of other small-scale applications of the industry. PVC plates should be placed at the construction site for more than 24 hours. The temperature of the plastic plates can be consistent with the indoor temperature to reduce the material distortion caused by the temperature difference. The use of professional trimming device for PVC plates at both ends of the pressure on the cutting edge. Both sides of the cutting width should not be less than 1 cm. When laying PVC plastic sheets, overlapping cuts shall be used in all material interfaces. The general overlap width should not be less than 3 cm. According to the different plates should be used for the corresponding special glue and scraping board. PVC sheet when laying, the plate will be rolled up one end, the back and front of the PVC plate clean, and then the dedicated glue scraping on the floor. Scraping glue must be evenly, unfavorable too thick. The effects of different binders are totally different. Special glue should be selected for reference to product specification

Product Catalog

We're Here to Help

  • +86 371 67882583
    +86 371 67882583
    selina@zzlanke.com.cn
    Room 1704,No.28 business outer ring       road,CBD,ZhengZhou,HeNan,China

Newsletter

Enter in your email address to receive deals
and coupons.
Bookmark us today!